72
2.
Use a damp cloth to wipe all surfaces
except for the display
. For stains or scuff marks, use
mild soap and water.
3.
Inspect all locking and adjustment mechanisms for signs of wear or damage.
Lubricating the System
We recommend applying a light grease to the treads of the FreeSway handles (if applicable) as
needed.
The following internal parts use white lithium grease for lubrication:
•
Spring assemblies
•
Push plates (8)
•
Acme threaded rods
To check these parts for adequate lubrication, remove the cover on the platform.
1.
Remove the four screws holding the cover.
2.
Remove the cover.
3.
Before adding more lubricant, redistribute the existing lubricant and then run the system.
WARNING:
When the Balance System is turned on without a cover, use extreme
caution when observing or working on the system.
1.
Spread the lubricant.
2.
Turn on the system.
If the parts need more grease, use white lithium grease.
For questions or assistance, contact the Biodex Customer Service Department.
Maintaining the Printer
Follow the instructions in the printer manual.
If replacement ink cartridges cannot be found, contact either Biodex Support or a Biodex
distributor.
Disposal
An appropriate waste disposal company is to be contacted (i.e., the local collection point for
waste separation). Properly dispose of the device at the end of its service life:
•
The device packaging is disposed of through resource recycling.
•
The metal parts of the machine go to scrap metal disposal.
•
Plastic parts are disposed of as hazardous waste.
The disposal of equipment must be in accordance with the respective
national regulations.
Wear parts are considered hazardous waste! After being replaced, wear
parts must be disposed of according to country-specific waste laws.