BIO RAD PowerPac Universal Power Supply, Инструкция по эксплуатации

Страница: 24 / 42

Page | 16
PowerPac Universal Power Supply Instruction Manual
Step Procedure Description
6. Add additional steps to the
method.
For each additional step (up to nine total) complete the
following:
a. On the Method screen, press the down arrow to highlight
the next EMPTY step.
b. Complete the step definition procedure in Step 5 (page
15) .
After you are finished creating the necessary steps for the
method, proceed to Step 7 to save the method.
7. Save the method. Use the following process to save the method:
a. On the Method screen, press the METHODS soft key to
access the Method List screen.
b. On the Method List screen, press the SAVE soft key to
save the method. Notice that the “(unsaved)” portion of
the method name is removed and the SAVE soft key
label changes to NEW.
c. If you need to make changes to the method, press the
OPEN soft key and edit the steps as needed ( for
assistance, see Section 3.4.2 ); otherwise, proceed to
Step 9.
NOTE: If you edit a method, pressing the SAVE soft key
from the Method List screen displays the Method Exists!
message. Press the OK soft key to save (overwrite) the
edited method.
8. Start the run. Press the run key to start the run.
9. Monitor the run. Use the Run screen to monitor run parameters or to pause a
run. The Run screen displays the following:
• The method being run
•
The present step being run in the method
• The elapsed time versus the programmed time
•
The present voltage, current, and power values
To pause the run, press the PAUSE soft key or . To
resume, press the RESUME soft key or . While paused,
you can edit the run (see Section 3.4.3 for details).
To stop the run, press
. The Run Stopped screen
appears. From this screen, you can rerun the method from
the beginning (RERUN soft key), resume the run (RESUME
soft key), or terminate the run (EXIT soft key).