BIO RAD PowerPac Universal Power Supply, Инструкция по эксплуатации

Страница: 22 / 42

Page | 14
PowerPac Universal Power Supply Instruction Manual
3.4 Method Mode Operation
This section describes how to program and perform a run in Method mode. Method
mode operation allows users to create and run single-step and multi-step methods. In
method mode, up to nine methods, each with up to nine steps, can be programmed,
stored, or edited.
3.4.1 Create and Run a New Method
This section describes how to create and run a new method.
Step Procedure Description
1. Set up the power supply. Refer to Section 3.1 for instrument setup.
2. Select the programming
mode.
On the Home screen, press the METHODS soft key to
display the Method List screen.
3. Create a new method. To begin creating a new method, press the NEW soft key.
The Method screen appears with S1 (EMPTY) flashing, and
the soft keys change to METHODS and EDIT.
NOTE: Up to nine methods can be stored in the PowerPac.
If there are already nine methods defined in the list, an
existing method will need to be deleted before a new
method can be added to the list. To delete a method use the
up/down arrow keys to select a method and then press the
DELETE soft key.
4. Name the new method. Use the following process to name the new method:
a. Press the up arrow key to select the method name field.
A blinking cursor appears to the right of the method
name (UNTITLED_).
b. Press the key multiple times to delete the
characters (right to left) in the method name.
c. Use the alpha-numeric keypad to enter the new
method’s name (up to 10 characters). For assistance,
refer to the alpha-numeric keypad description (page 5) .
The example to the left shows a method name of
Testing1.
d. Press the down arrow key to accept the method name.
The S1 (EMPTY) step resumes flashing, which indicates
that Step 1 is undefined and is ready for you to edit it.