BIO RAD PowerPac Universal Power Supply, Инструкция по эксплуатации

Страница: 23 / 42

PowerPac Universal Power Supply Instruction Manual
Page | 15
Step Procedure Description
5. Edit the first step in the
method.
a. Press the EDIT soft key to open the Step Edit screen
and edit Step 1 (S1).
b. Use the V/mA/W soft key to select the control parameter
(volts, milliamps, or watts) according to your preference.
Each press of the V/mA/W soft key cycles through the
parameters. The selected control parameter appears on
the left in large bold text, and is set to its minimum value.
The limit parameters appear on the right in smaller text
on two lines, and are set to their respective maximum
values.
c. Adjust the run parameters for the current step.

See a finished example on the left.
The parameter ranges are as follows:
• V (volts): 10–2500
•
mA (milliamps): 10–2500
• W (watts): 1–500
•
VHOURS (timer volt-hours): 1–99999
• hh:mm (timer hours and minutes): 00:01–99:59
i) Use the alpha-numeric keypad to enter the Constant
value.
ii) Press the NEXT soft key to highlight the timer.
iii) Press the up/down arrow keys to select the timer
mode: UNTIMED, VHOURS, or hh:mm.
NOTE:
If you are creating an untimed run, skip to
Step 5.c.v. Be aware that steps subsequent to an
untimed step are ignored.
iv) Press the PREV soft key or to highlight the
timer value, and use the alpha-numeric keypad to
enter the timer value.
v) Press the NEXT soft key (twice for timed runs) to
highlight the top-right limits parameter, and use the
alpha-numeric keypad to set the parameter value.
vi) Press the NEXT soft key to highlight the lower-right
limits parameter, and use the alpha-numeric keypad
to set the parameter value.
vii) Press to navigate to the Method screen. Before
adding more steps to the method, or saving the
method, you must navigate to the Method screen.
If you need to add more steps, proceed to Step 6;
otherwise, skip to Step 7 to save the method.