NCR-80 Four-wire 4-20 mA/HART
925-0332 Rev B
3 Production description
11
3.3 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its capacity to handle normal
loads during transport is assured by a test based on ISO 4180.
The packaging of standard instruments consists of environment friendly, recyclable cardboard.
For special versions, PE foam or PE foil is also used. Dispose of the packaging material via
specialised recycling companies.
Transport must be carried out in due consideration of the notes on the transport packaging. Non-
observance of these instructions can cause damage to the device.
The delivery must be checked for completeness and possible transit damage immediately at re-
ceipt. Ascertained transit damage or concealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and stored according to the ori-
entation and storage markings on the outside.
Unless otherwise indicated, the packages must be stored only under the following conditions:
●
Not in the open
●
Dry and dust free
●
Not exposed to corrosive media
●
Protected against solar radiation
●
Avoiding mechanical shock and vibration
●
Storage and transport temperature see chapter “
Supplement - Technical data - Ambient con-
ditions
”
●
Relative humidity 20 … 85 %
3.4 Accessories and replacement parts
The display and adjustment module BinDisc is used for measured value indication, adjustment
and diagnosis. It can be inserted into the sensor and removed at any time.
You can find further information in the operating instructions “Display and adjustment module
BinDisc”.
The protective cover protects the sensor housing against soiling and intense heat from solar
radiation.
Screwed flanges are available in different versions according to the following standards: DIN
2501, EN 1092-1, BS 10, ASME B 16.5, JIS B 2210-1984, GOST 12821-80.
For mounting the instrument with plastic horn antenna to a socket, two flange versions are avail
-
able: the combi compression flange and the adapter flange
You can find additional information in chapter “
Mounting
” of this operating instruction.
A mounting strap is available for mounting the instrument with plastic horn antenna to the wall or
ceiling.
You can find additional information in chapter “Mounting” of this operating instruction.
