Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
7
/
20
Assembly page 7/20
Fax +32 030 9904733
INSTALLATION
•
After removing the packing materials, check the integrity of the heater; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger.
•
Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity (230V~ 50Hz). In the event of incompatibility between the electric outlet and the
plug of the heater, have the outlet replaced with another more suitable type by professionally
qualified personnel, who will make sure that the section of the wires of the outlet is appropriate for
the absorbed power of the heater (10A). In general, the use of adapters or extension cords is not
recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the heater.
•
Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
•
Don’t hang it on the wall.
•
Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
•
The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
•
Position the fan heater far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat. Make sure that there is 120 cm of free space in front of the fan heater and 100 cm
on the sides. Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool. (to avoid drops of water falling on the heater or the heater falling in the water), or
in places where it could be subject to shocks.
Warning: this symbol indicates the anti-tipping switch. If any buttons have been pressed, the
appliance will start to function immediately.
•
The support surface must be stable (exclude shelf) and not sloping (since the heater could tip over).
•
Make sure that the n.2 air-intake grids is not obstructed by objects, fabrics or anything else to avoid
the heater overheating or breaking.
•
Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
•
In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
OPERATION
The fan heater is equipped with an on-off switch, power regulator switch (1000W and 2000W), and
oscillation (i.e., 90° rotation alternatively right and left).
For use, the fan heater operates as follows:
1)
Plug the fan heater into the electric outlet: the lower indicator light comes on, signaling the
presence of voltage.
2)
Turn on the 0/I switch and the fan starts.
3)
Turn on one or both of the 1000W switches to select 1000W or 2000W Watts of power,
respectively.
4)
If you wish the oscillation function, press the “swing” button.
