Operating Manual no.
057-2-6-0017-R0
P. 29
Version 2021
EN
The support surfaces must be carefully cleaned to remove traces of oil or grease.
8.3.3
Cleaning the work areas
Keep the work area clear of any material that may hinder the operations of the employees.
Keep the surrounding areas clean; in particular from oil, grease, etc. that can make the floor
slippery.
Use suitable vacuum cleaners and proper equipment.
8.4
Problems and solutions
The most common problems encountered during the work, the probable causes that determine
them and the possible solutions to be applied in order to eliminate them are listed below.
When implementing the suggested remedy, always follow the instructions described in the
Instructions section to which the remedy refers.
Bike-Lift EUROPE s.r.l. will solve all the troubles that cannot be eliminated by means of the
annexed instructions.
TROUBLE
PROBABLE CAUSE
SOLUTION
Operating on the
button panel the
lifting
platform
does
not
go
up/down
No voltage
Check the mains connection
plug
Improper operation of the button unit
on the button panel
Replace the button unit
Faulty actuator
Check the operation of the
actuator, and if necessary,
replace it.
The weight of the load is greater than
the rated capacity of the lift
Refer to the technical data sheet
or plate, and if necessary,
reduce the load.