BGU KSA 380 E, Оригинальное руководство пользователя

Страница: 12 / 40

Seite 12
Do not, under any circumstances, alter or by-pass the safety devices
and protections of your processor that must be in good operating-
conditions at all times.
Before starting, inspect the machine for evident, visible damages and
unusual conditions. Check the state of all hydraulic hoses, fittings and
connectors and seal eventual leaks, if required. Do not check for leaks
with your hand. Leaks can be located by passing a piece of cardboard
or wood around the suspected leak and looking for discoloration.
High-pressure fluid escaping from a very small hole can be almost
invisible. Escaping fluid under pressure can have sufficient force to
penetrate skin, causing serious injury or even death.
Altering the equipment, or using the equipment in such a way as to
circumvent its safeties, could result in serious or fatal injury.
NEVER operate your processor when it’s in need of repair or in poor
mechanical conditions.
5.4 Adjusting the ram stroke length
Timber can be cut into logs of variable length by changing the position
of the length gauge on the other side of the chainsaw. To do this, first
release the fixation screw and then slide the plate into the new
desired position. Tighten the clamp back in place before starting to
work again.
5.5 4-way wedge
The machine is supplied with a standard 4-ways wedge (see Figure 4)
that allows you to split your logs into 2 or 4 pieces in one stroke.
Adjust the height of the wedge in its lowest position to split the log into
two pieces and lift it up till the crossing matches the core of your log to
split into four sections.
The log length is manually adjusted by means of the special control
lever located on the control deck (see Figure 5).
On request, the machine can be additionally delivered with a 6-wings
(star-shape) wedge (see Figure 7).
Use of this wedge allows splitting of the log in 6 pieces in one single
stroke.
Wedge lift is manually adjusted by means of the special control
lever (see Figure 5).
The installed stopper for the length allows the ridgeless adjustment of
the log between 200 an 600 mm, The splitting wedge can be put in the
6 different positions using the hand lever. (see Figure 6).
Figure 5
Figure 4
Figure 6