BGU KSA 380 E, Оригинальное руководство пользователя

Страница: 21 / 40

Seite 21
Never operate the log splitter without or with low oil in the tank because
in this case, air is likely to enter the oil line and cause operating troubles,
reduced splitting accuracy and awkward back and forth movements.
Moreover, air in the hydraulic line may cause even major damages to
the hydraulic pump.
Do the first oil change after every 50 operation hours and then again,
after each 200 operation hours or once a year.
Recommended hydraulic oils: DEA HD B 46, Shell Tellus 10 - 46,
Esso Nuto H 46
Due to the environmental polluting impact of used oil, it is recommended
to use a basket or a container to collect oil when changing. Also make
sure that this container is perfectly tight and at least of the same capacity
as the hydraulic tank (see technical specs).
If you’re using a smaller container than the actual tank capacity make
sure to drain oil in more than one stage so that no oil gets spilled on the
ground. Waste oil is a pollutant agent and must be disposed in accordance
to the applicable regulations in the country of use!
After each new oil fill run the machine 3 or 4 cycles without tightening
the cap on the tank. Extending the cylinder piston draws the hydraulic
fluid through the system and expels any trapped air in the system.
Provide at least one complete oil change of the angular gearbox once
a year.
9.4 Stretching the infeed belt
Check the tension and sliding efficiency of the conveyor belt at periodical
intervals.
In order to stretch or change tensioning of the conveyor belt, first provide
adjustment of the clamping bolts located on each side of the conveyor
(see Figure 29).
Release the locknut on each bolt and then unscrew the clamping bolts
(3 bolts on each side). Turn the clamping bolts to adjust belt tension and
concurrently adjust the pulley so that the belt always slide in the middle
of the conveyor carriage.
As soon as proper stretching is obtained tighten all bolts to the original
torque.
9.5 Adjusting the infeed belt
Tension of the infeed belt can be adjusted by means of the special side
bolts.
Turn the bolts counter clockwise to stretch the belt. (see Figure 30).
Fig. 30
Fig. 29