BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
MEASURING RESISTANCE
1. Connect the black test lead to the COM terminal and the
red test lead to the
VΩmAHz
terminal.
2. Set the function switch to
position. Then press the
to button to select resistance function (the symbols
and
and capacitance measurement unit do not
appear on the screen).
3. Connect the test leads across the object to be tested.
4. Read the reading on the screen.
Note:
1. For measurements
>1MΩ,
the meter may take a few
seconds to stabilize reading. This is normal for high
resistance measurements.
2. When the input is not connected, i.e. at open circuit,
OL
will be displayed as overrange indication.
3. Before measurement, disconnect all power to the circuit to be measured and discharged all capacitors
thoroughly.
CONTINUITY TEST
1. Connect the black test lead to the
COM
terminal and the
red test lead to the
VΩmAHz
terminal.
2. Set the function switch to
position. Then press the
button until the symbol
appears on the screen.
3. Connect the test leads across the circuit to be tested.
4. If the resistance is less than about 200, the built-in buzzer
will sound.
Note:
Before test, disconnect all power to the circuit to be
tested and discharged all capacitors thoroughly.
MEASURING FREQUENCY
1. Connect the black test lead to the
COM
terminal and the
red test lead to the
VΩmAHz
terminal.
2. Set the function switch to
Hz %
position. Then press the
Hz %
button until
Hz
appears on the screen.
3. Connect the test leads across the source or circuit to be
tested.
4. Read the reading on the screen.
Note:
1. For frequency measurements, the range exchange is
automatic, and the measurement range is: 0MHz -
10MHz.
2. The voltage of input signal should be between 1V rms
and 20V rms. The higher the frequency, the higher the
required input voltage.
3. For measurements < 10Hz, the amplitude of input signal must be more than 2V rms.
