Bezzera ELLISSE DE Series, Инструкция по эксплуатации

Страница: 34 / 76

34
MOD.
BEZZERA ELLISSE
put key (Fig. 07- B pos. f)
2) stop the output once the wanted quantity has
been reached, by pressing once again the
continuous output key (Fig. 07- B pos. f)
Warning: The machine is equipped
with an automatic safety device that
stops continuous output after the third
consecutive litre.
ELLISSE TE (Fig. 07-C)
1) Remove the filter holder from the supply
group.
2) Load the filter holder with ground coffee, press
the coffee paying attention not to dirty the bor-
der of the filter holder.
3) Hook back the filter holder in its location.
4) Act on the coffee supply command, by press-
ing one of the keys (Fig. 07-C), based on the
dose to supply.
To change the programming of doses, follow the
instructions indicated in paragraph 5.7 of this
booklet.
The machine is also conceived for continuous
output:
1) start the output by pressing the continuous out-
put key (Fig. 07- C pos. f)
2) stop the output once the wanted quantity has
been reached, by pressing once again the
continuous output key (Fig. 07- C pos. f)
Warning: The machine is equipped
with an automatic safety device that
stops continuous output after 600 sec-
onds.
5.4 Steam supply
1) To avoid refluxes of fluid inside the boiler, ex-
haust the steam by acting on the tap’s knob
(fig. 01; pos. 3).
2) Introduce the steam nozzle (Fig. 01; pos 2) in
the fluid container to heat up.
3) Press the steam key (Fig. 01 pos 3). The quan-
tity of steam supplied is proportional to the
opening of the tap; the greater is the opening
of the tap, the greater the quantity of steam
supplied will be.
4) Once the output of steam is concluded, re-
move the fluid container and clean immedi-
ately the steam nozzle with a wet cloth from the
residues of the heated fluid.
Warning: Do not touch the steam nozzle directly
because it is hot.
5.5 Picking up of hot water
ELLISSE PM
1) Position the water container under the nozzle
(Fig. 01; pos 6).
2) Act on the tap (Fig. 01; pos 7a) to pick up the
quantity of water needed.
ELLISSE DE
1) Position the water container under the nozzle
(Fig. 01; pos 6).
2) Press key (Fig. 01 - B; pos e) to pick up the
quantity of water needed.
ELLISSE TE
1) Position the water container under the nozzle
(Fig. 01; pos 6).
2) Press key (Fig. 01 - C; pos e) to pick up the
quantity of water needed.
Warning: Do not touch the nozzle directly be-
cause it is hot.
5.6 Turning off the machine
1) Close the water shut-off valve
2) Bring the switch (Fig. 06; pos 1) in pos 0 and
check that the green light is off.
3) Bring the omnipolar switch of the electric net-
work in idle position “0”.
4) Exhaust the pressure of the steam tap.
5.7 Programming of doses (ELLISSE
DE/TE)
To adjust doses in DE/TE machines, proceed as
follows:
press the continuous output /programming/stop
key (Fig. 07 B/C post f), keep it pressed until the
relative light starts flashing, notifying (the machine
must not supply water) the beginning of the pro-