Bezzera ELLISSE DE Series, Инструкция по эксплуатации

Страница: 33 / 76

33
MOD.
BEZZERA ELLISSE
room. This device is equipped with a terminal
in order to connect an external conductor with
nominal section in compliance with current leg-
islations.
5 – USE OF MACHINE
5.1 Start up of machine and loading
of water inside boiler
(Fig. 06)
Open the water shut-off valve.
Bring the lever of the omnipolar switch belonging
to the electric system on ON.
When the switch (fig. 06; pos 1) is brought in po-
sition 1, the water is loaded inside the boiler; af-
ter 120 seconds of loading, the machine goes in
alarm status; bring the switch in 0 position and re-
peat the operation by pressing the same switch a
few times, until the pump has completely loaded
the boiler and shuts off.
Once the minimum level has been reached, the
red light (Fig. 06; pos 4) will turn off and by bring-
ing the switch in \/\/\ position, the yellow light will
turn on (Fig. 06; pos 3).
N.B.: It is suggested not to bring the
switch in \/\/\ position when the red
light is on.
Wait that the boiler’s pressure gauge (Fig. 01;
pos 9) indicates a pressure between 1 and 1.2
bar (0.1 – 0.12 MPa) prior to use the machine.
5.2 Heating
(Fig. 06)
To make sure that the machine has reached the
right thermal balance between temperature and
pressure, when the boiler’s gauge indicates a
pressure between 1 and 1.2 bar (0.1 – 0.12
MPa), press the steam tap (Fig. 01; pos 7) and
exhaust the steam 2 or 3 times in the discharge
basin.
The green light (fig. 06; pos 2) indicates that the
machine is on.
The red light (fig. 06; pos 4) warns about the in-
sufficient water level inside the boiler.
The yellow light (fig. 06; pos 3) signals the ena-
bling of the resistor.
Warning:
when the red light (fig. 06; pos 4) is on, a safety
device does not allow the machine to work; con-
tact the technical assistance service.
5.3 Preparation of coffee (Fig. 07)
Warnings:
- Do not remove the filter holder when the de-
vice is on: burning hazard.
- Do not touch directly the metal part of the filter
holder and group: burning hazard.
- The standard doses for the filters are 6/8 grams
for a dose and 12 grams for two doses.
ELLISSE PM (Fig. 07-A)
1) Remove the filter holder from the supply
group.
2) Load the filter holder with ground coffee, press
the coffee paying attention not to dirty the bor-
der of the filter holder.
3) Hook back the filter holder in its location.
4) Press Key ON/OFF (Fig. 07 – A pos. a) to
stop output once the wanted dose has been
reached.
ELLISSE DE (Fig. 07-B)
1) Remove the filter holder from the supply
group.
2) Load the filter holder with ground coffee, press
the coffee paying attention not to dirty the bor-
der of the filter holder.
3) Hook back the filter holder in its location.
4) Act on the coffee supply command, by press-
ing one of the keys (Fig. 07-B), based on the
dose to supply.
To change the programming of doses, follow the
instructions indicated in paragraph 5.7 of this
booklet.
The machine is also conceived for continuous
output:
1) start the output by pressing the continuous out-