Bezzera BZ16, Инструкция по эксплуатации

Страница: 29 / 72

29
MOD.
BEZZERA BZ16
water.
Insert the plug in the electrical socket.
Turn the main switch (Fig. 01; pos. 1) to position
“ON“.
Water is automatically loaded into the boiler.
PM VERSION
A safety device will interrupt the motor-pump after
120 seconds if the maximum water level is not
reached in the boiler.
To restore working mode, turn off and turn on the
machine again.
DE VERSION
A safety device will interrupt the motor-pump after
120 seconds if the minimum water level is not
reached in the boiler.
The machine will signal this alarm by the flashing
the five leds on the keypad
To restore working mode, turn off and turn on the
machine again.
5.2 Heating
To ensure that the machine has reached the
proper thermal balance between pressure and
temperature, when the boiler’s gauge (Fig. 01;
pos. 14) will indicate a pressure between 1 and
1.2 bar (0.1 – 0.12 MPa), open the steam tap
(Fig. 01; pos. 9) and exhaust the steam 2 or 3
times in the discharge basin.
The light , if on, points out the machine is in
working order; if off, it means that the water level
in the tank or in the boiler (S version), in the boil-
er (R version) is not enough.
5.3 Preparing coffee
1) Remove the filter holder (Fig. 01; pos. 7) from
the distribution unit (Fig. 01; pos. 6).
2) Load the filter holder with ground coffee, press
the coffee down taking care to not dirty the
edge of the filter holder.
Start erogation without filter holder for about 2/3
seconds MAX (GROUP FLUSH).
3) Reattach the filter holder in its housing.
PM VERSION
4) Start up coffee distribution by turn the distribution
button (Fig. 01; pos. 2).
5) Stop distribution when the desired quantity is
reached, by turn the distribution button again.
DE VERSION
4) Use the coffee distribution keypad (Fig. 05),
by pressing one of the keys, depending on the
desired dose.
To change dose programming, follow the
instructions in paragraph 5.7 of this booklet.
The machine is set for continuous distribution:
press the key
to start up distribution, press again to stop.
Warnings :
- Do not remove the filter holder full of coffee when
the machine is working, as it is pressurised.
- Do not touch the metal part of the filter holder
directly as it is hot.
- The standard doses for the filters are 6/8
grams for a dose and 12/14 grams for two
doses.
5.4 Steam distribution
(Fig. 06)
1) In order to avoid eddies in the boiler, let off
steam by turning the relevant knob (fig. 01;
pos. 9).
2) Insert the nozzle into the container with the
water to be heated (fig.05).
3) Turn the steam knob.
The outlet steam depends on the knob turning:
the more the knob is turned, the more the steam
is let off .
4) After the steam has been blown off, turn the
knob off, take out the container and clean im-
mediately the nozzle with a damp cloth in or-
der to remove residual heated water.