BEYERTONE
®
www.beyertone.com
© IV-2022 BEYERTONE GmbH
Installation guide - beyertone
®
multiLAN Ver. 3
8/40
The following drawing shows the position of the module and the jumpers:
The ports of the PBX have to be programmed correctly to obtain the desired
announcement functions.
To set the volume level of the announcements, load announcement files and make
all other settings e.g. the call transfer numbers, you have to use a browser via LAN
(see Section 3, 4.1 / 4.2 and 5.2 / 5.3).
2.3 Network and power supply
First
connect the LAN port of the beyertone
®
multiLAN to a free 10/100 Mbps port in
the network that will be used to access the appliance and download audio updates.
The green LAN socket LED means "connected", the yellow LED "data".
Configuration and transfer/download of audio files is done exclusively via the LAN
interface. When taking the appliance into operation you can assign a static IP
address or you can have the network parameters (IP address, gateway address,
plus, if applicable, DNS and NTP address) assigned automatically via DHCP (factory
setting).
Then
connect the mains adapter to the POWER socket on the appliance and then
plug the mains adapter into a socket outlet. The (green) 'POWER' LED lights up,
indicating that the appliance is ready for use. Use only the mains adapter supplied.
Alternatively the unit can be powered by PoE.
For information on the status indications via the LEDs on the front panel - e.g.
regarding the network status -, please refer to Section 9.5.
