Beurer BM 54, Инструкция по эксплуатации

Страница: 27 / 148

27
Bluet
ooth
®
The Bluetooth
®
symbol flashes on the display.
• Use the M1/M2 memory buttons to select whether au-
tomatic Bluetooth
®
data transfer is to be activated ( Blu-
etooth
®
symbol flashes) or deactivated ( Bluetooth
®
sym-
bol is not shown) and confirm with the START/STOP
button .
Bluetooth
®
transfers will reduce the battery life.
7. Usage
Ensure the device is at room temperature before measuring.
The measurement can be performed on the left or right arm.
7.1 Attaching the cuff
Place the cuff onto the bare upper arm.
The circulation of the arm must not be
hindered by tight clothing or similar.
The cuff must be placed on the upper
arm so that the bottom edge is positi-
oned 2 – 3 cm above the elbow and
above the artery. The line should point
to the centre of the palm.
Now tighten the free end of the cuff, but
make sure that it is not too tight around
the arm and close the hook-and-loop
fastener. The cuff should be fastened so
that two fingers fit under the cuff.
Now insert the cuff line into the connec-
tion for the cuff connector.
The cuff is suitable for you if the index
mark ( ) is within the OK range after
fitting the cuff.
If the measurement is performed on the right upper arm, the
line should be located on the inside of your elbow. Ensure
that your arm is not pressing on the line.
Blood pressure may vary between the right and left arm, which
may mean that the measured blood pressure values are different.
Always perform the measurement on the same arm.
If the values between the two arms are significantly different,
please consult your doctor to determine which arm should be
used for the measurement.
Important: The device may only be operated with the original
cuff. The cuff is suitable for an arm circumference of 22 to 44 cm.
M1
SYS
mmHg
DIA
mmHg
PUL
/min
M2