Beurer medical GL 50 evo, Руководство пользователя

Страница: 21 / 44

Beurer GL50 evo 21
5.2 Preparing the lancing device for taking a sample
1
Remove the cap
Securely hold the monitor with one hand on the lancing device cover.
With your other hand, remove the cap from the monitor’s lancing device.
2 Insert the lancet needle
Insert a sterile lancet needle into the lancing device.
Note
Your starter set contains lancet needles in 2 different sizes. If you are
unable to take an adequate blood sample using the smaller needles
(purple, 33G), please use the slightly larger needles (blue, 28G).
Push firmly on the lancet until it audibly engages and it cannot be
pushed further into the holder.
3
Remove the protective lancet disc
Remove the protective lancet disc by bringing it into a horizontal position
and taking it off. Retain the protective disc for the safe disposal of the
used lancet needle after taking a blood sample.
4
Place the cap onto the lancing device. Make sure that the curved part
of the cap fits on the curved part of the lancing device. Press firmly on
the cap until it audibly engages.
5
Select the penetration depth
You can set seven different penetration depths on the lancing device
using the dial with printed numbers.
• 1 to 2: soft or thin skin
• 3 to 5: normal skin
• 6 to 7: thick or calloused skin
Turn the dial until the required bar is in the centre of the black marking.
6
Tension the lancing device
Pull back the slider in the direction of the arrow (on the image: to the
right) until it stops and then release. The slider automatically springs
back into position. The lancing device is now tensioned.