BETCO MOTOMOP, Руководство оператора и каталог запасных частей

Страница: 9 / 36

9
7. BATTERY MAINTENANCE AND DISPOSAL
To power the MotoMop, use only the battery supplied in the package or supplied by a Betco authorized service provider.
OTHER BATTERY TYPES CANNOT BE USED.
The MotoMop is powered by a lithium-ion battery. The battery compartment can accommodate a single battery slot at 25.55V.
MACHINE PREPARATION
8. PREPARING FOR WORK CYCLE
Before beginning to work, it is necessary to:
1. Before using the machine, make sure it is in a good, safe working condition. If there are items that are is not in order, the
machine must not be used.
2. Position the handle so it is vertical.
3. Activate the machine using the main switch (1) (Fig.1).
4. Check the battery charge level. There are four LEDs (2) on the battery to show the charge percentage (Fig.2). If all the LEDs
are lit up, the battery is fully charged; if they are all switched off, the battery is completely discharged.
5. Turnoff the machine using the main switch (1) (Fig.3).
6. Remove the battery (3) from the machine. To free the battery, slide the lock lever (4) in the direction of the arrow (Fig.4).
7. Remove the battery from the machine using the molded handle (Fig.5).
8. Make sure the condition of the squeegee blades are suitable for the work you want to perform. If they are damaged, perform
the necessary maintenance (read “MAINTENANCE”).
9. Make sure the condition of the brush is suitable for the work you want to perform. If it worn, perform the necessary
maintenance (read “MAINTENANCE”).
10. Rotate the front cover (5) as far as it will go - do this with the aid of handle (6) (Fig.6).
11. Remove the solution tank from the device (Fig.7). Carefully place it on the floor.
12. Remove the detergent solution filling cap (7) from its seat on the solution tank (Fig.8).
13. Fill with clean water, at a temperature no higher than 120° F and no lower than 50° F.
14. Add the liquid detergent to the solution tank in the concentration and manner indicated on the detergent manufacturer's
label.
15. Replace the detergent solution filling cap (7) in its seat on the solution tank (Fig.9).
16. Insert the solution tank in the device (Fig.10).
17. Rotate the front cover (5) as far as the work position - do this with the aid of the handle (6) (Fig.11).
18. Insert the battery in the battery compartment in the rear part of the device.