12
1. Turn off the machine using the main switch (1) (Fig.1).
2. Rotate the handle so it is vertical.
3. Remove the battery (2) from the machine. To remove the battery, slide the stop lever (3) in the direction of the arrow (Fig.2).
4. Remove the battery from the machine using the handle molded into (Fig.3).
5. Rotate the front cover (4) as far as it will go - do this with the aid of the handle (5) (Fig.4).
6. Remove the brush housing cover (6) and slide the stop levers (7) as indicated by the arrows (Fig.5).
7. Remove the brush (8) from the machine (Fig.6).
8. Clean the brush under running water to remove any impurities present in the bristles. Check that the bristles are not worn; in the event of excessive wear,
replace the brush (the bristles should be at least 10 mm long).
9. Fit the brush (8) on the pin in the brush motor (the brush can only be inserted in one direction) (Fig.7).
10. Replace the brush housing cover (6) and slide the stop levers (7) as indicated by the arrows (Fig.8)
11. Remove the recovery tank (9) from the machine - do this with the aid of the handle (10) (Fig.9).
12. Remove the recovery tank cover (11), then rotate the handle (10) completely to free the pin (12) from the clamp (13) (Fig.10).
13. Use a clear water and then a damp cloth to thoroughly clean the rotation pivot (14) of the vacuum motor floats (Fig.11).
14. Use clear water and then a damp cloth to thoroughly clean the central float (15) (Fig.12).
15. Clean the recovery tank with clear water; the entrance hole to this compartment is identified by the letter (A), while the outlet is identified with the letter (B)
(Fig. 13).
16. Clean the vacuum motor air conveyor compartment with air; the entrance hole to this compartment is identified by the letter (C), while the outlet is identi-
fied with the letter (D) (Fig. 14).
17. Replace the cover on the recovery tank, then rotate the handle (10) completely to lock the pin (12) on the clamp (13).
18. Remove the solution tank from the machine (Fig.15).
19. Remove the filter cartridge (17) and clean it with clear water to remove any impurities that might be attached. If necessary, replace it (Fig.16).
20. Remove the vacuum duct cleaning brush (18) from its support (Fig.17).
21. Clean the inside of the vacuum duct (19) with the brush (18) (Fig.18).
22. Replace the vacuum duct cleaning brush (18) in its support (Fig.19).
23. Rotate the front cover (4) as far as the work position - do this with the aid of the handle (5) (Fig.20).
24. Lock the handlebar in the horizontal position (Fig.21).
MAINTENANCE
