10
During clutches’ mounting operation, it is
necessary to give special attention. A wrong
installation can cause clutch bell deformations
or a loss of regulation.
Consequently warranty replacements become difficult
to recognise because damages can occur due to a bad
mounting.
To avoid this situation and to grant a right assembling and
disassembling of these SAC clutches, it is necessary to
use a special tool.
DISMOUNTING:
The usage of this special clutch tool is basic also to
dismount SAC clutches. In fact if we try to dismount a
SAC clutch, the clutch will unadjust, causing problems
during mounting operations, have a shorter life and cause
a lot of vibrations.
Follow these instructions:
● Mount the handle into the main threaded shaft, locking the
picture 1.
● Unscrew the 3 screws at 120° (or 4 screws at 90° fig. 2).
● Mount the suitable screws M6 or M7 or M8 (legs) supplied in
this set (fig. 3 and 4);
● Install the special clamp tool (3 or 4 shanks) and lock it with
the M8 locking knobs
● Rotate the special tool’s handle to compress the cup spring
totally (fig. 5).
● Unscrew now the remaining flywheel locking screws (fig. 6).
● Remove the M8 locking knobs from the special tool, then the
special tool and the three legs.
● Now the pressure plate is raised and the clutch bell touches
the flywheel, becoming easy to unscrew and
remove the clutch (fig. 7).
1
2
3
4
5
6
1438SAC.indd 10
1438SAC.indd 10
03/02/20 10:39
03/02/20 10:39
