BESV TRB1, Техническое руководство

Страница: 12 / 25

12
3.5 Display unit
-
Wiring h remote control unit, supplied with 2 x M3x16 hexagon socket screws and
1 x M3x10 hexagon socket screw (lock screw) (C54760)
-
Display unit (C54764)
-
SW 2.5 hexagon socket wrench
-
Torque wrench
-
M3x16 hexagon socket screw = 0.5 Nm
-
M3x10 hexagon socket screw (lock screw) = 0.3-0.5 Nm
-
Suitable for handlebar diameter: 31.8 mm
3.5.1 Fitting the holder and display unit
Check the specified handle bar diameter
before assembly.
Use suitable rubber pads for smaller hand-
lebars.

Position clamping brackets (1) in the
middle of the handlebar.
-
Fold the two halves (2) of the bracket
around the handlebar and secure lightly
with hexagon socket screws (3).
 Align holder and tighten hexagon socket
screw (3).
-
Check the distance between the clam-
ping brackets is as specified.
-
Make sure that you apply the specified
torque.
Route cables according to your own specifi-
cations and connect with drive unit. For more
information, see
“Cable assignment” on
page 11.
Use guide grooves provided in the holder
when mounting the display unit.
 Place display unit (4) with guide groove
(A) in the guide opening (B) of the holder.
-
Push display unit (4) down until it clicks
into place.
Optional
-
The lock nut prevents unwanted removal
of the display unit.
-
Screw lock nut (5) into the holder from the
bottom.
-
Make sure the thread of the lock nut (5) is
slightly below the hole and not sticking
out.
5
B018-0
1
2
3
1
1
4
A
B