7
FILLING POOL WITH WATER
ATTENTION:
Do not leave pool unattended while filling with water.
1. Fill pool to drain valve.
STOP
2. Turn water off. Check that the water is not collecting on any side to
ensure the pool is level. If pool is not level, drain water and re-level
ground by digging out. Never attempt to move the pool with water in
it, serious personal injury or damage to the pool may result.
NOTE:
Your pool may contain a great deal of pressure. If your pool
has any bulge or uneven side then the pool is not level, the sides
may burst and the water may discharge suddenly causing serious
personal injury and/or damage to property.
3. If level, fill pool to lowest pump valve.
STOP
4. Turn water off. Check valves for secure fit.
5. Fill the pool until the water reaches the welding line located
4cm-12cm (1.6''-4.7'') from the top of the pool.
DO NOT OVERFILL
as this could cause the pool to collapse. In times of heavy rainfall
you may need to empty some of the water to ensure the level is
correct.
6. Check pool for any leaks at valves or seams, check any evident
water loss. Do not add chemicals until this has been done.
NOTE:
Drawings for illustration purpose only. May not reflect actual
product. Not to scale.
ATTENTION:
Do not use pump when pool is in use.
During the season of use of the swimming pool, the filtration system
must be necessarily put into service every day, enough for a long time
to assure at least a complete renewal of the volume of water.
POOL MAINTENANCE
REPAIR
Check pool for any leaks from valves or seams, check the ground cloth
for any evident water loss. Do not add chemicals until this has been
done.
NOTE:
In the event of a leak, patch your pool using the underwater
adhesive repair patch provided. Refer to the FAQ’s for further
information.
DISMANTLING
1. Unscrew the drain valve cap on the outside of the pool counter
clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose
in the area where you are going to drain your pool. (Check local
regulations for drainage by-laws).
3. Screw control ring of the hose adaptor onto the drain valve
clockwise. The drain valve will be open and water will start to drain
automatically.
ATTENTION:
Water flow can be controlled with the
control ring.
4. When draining is finished, unscrew the control ring to close the
valve.
Parameters
Water clarity
Colour of the water
Turbidity in FNU/NTU
Nitrate concentration above that of fill water in mg/l
Total organic carbon (TOC) in mg/l
Redox potential against Ag/AgCI 3,5 m KCl in mV
pH value
Free active chlorine (without cyanuric acid) in mg/l
Free chlorine used in combination with cyanuric acid in mg/l
Cyanuric acid in mg/l
Combined chlorine in mg/l
Values
clear view of the pool bottom
no colour should be observed
max. 1,5 (preferably less than 0,5)
max. 20
max. 4,0
min. 650
6,8 to 7,6
0,3 to 1,5
1,0 to 3,0
max 100
max 0,5 (preferably close to 0,0 mg/l)
Warning:
If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of children. Pool
water treatment is essential for the safety of the users. Using
chemicals inappropriately will cause property damage and personal
injury.
NOTE:
The pump is used to circulate the water and to filter small
particles. In order to keep your pool water clean and hygienic, you
must also add chemicals.
1. It is recommended not to fill the pool with catchment water, drilling
water, or drainage well water: these waters generally contain
polluted organic substances including nitrates and phosphates.
Filling pools with water from the public network is advised.
2. Always keep your pool clean and apply the correct pool chemicals.
Unsanitary water is a serious health hazard. It is recommended to
use disinfectant, flocculant, acid or alkali chemicals to treat your
pool.
3. Clean the PVC liner regularly with non-abrasive brushes or a pool
vacuum cleaner.
4. Throughout the season, the water filtration system must run long
enough each day to clean the entire volume of water in the pool.
5. Check the filter cartridge (or sand in a sand filter) regularly and
replace dirty cartridges (or sand).
6. Regularly check the screws, bolts and all the metal parts for rust.
Replace if necessary.
7. If it rains, check that the water level is not higher than the specified
level. If water exceeds the specified levels, drain the pool to the
specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION:
Do not leave the drained pool outside.
The following parameters ensure good quality water
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Air dry pool.
ATTENTION:
Do not leave the drained pool outside.
STORAGE
1. Please remove all the accessories and spare parts of the pool and
store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent
pool from sticking together, fold pool carefully. If pool is not
completely dry, mold may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate
temperature between 5ºC / 41ºF and 38ºC / 100ºF.
4. During the rainy season, pool and accessories should be stored as
per above instructions also.
5. Improper draining of the pool might cause serious personal injury
and/or damage to personal property.
6. We strongly recommend the pool is disassembled during the off
season (winter months). Store in a dry location out of children’s
reach.
4cm-12cm
(1.6"-4.7")
0°
