25
10cm
(4”)
3
2
2
3
9
7
8
7
6
5
4
8
9
10cm
(4”)
3
2
2
3
9
7
8
7
6
5
4
8
9
10cm
(4”)
3
2
2
3
9
7
8
7
6
5
4
8
9
–
Thread the top cover thread guide by pulling the
thread towards the left until it slips under guide
(2)
. Then pull thread along the right side of
button as illustrated.
–
While holding thread with fingers, pass it
between the tension discs and pull thread down
to make certain it is properly located in between
the tension discs
(3)
.
–
Continue to thread points
(4)
–(
9)
.
Before threading eye of needle, slip thread behind
thread guide located on the bottom of the needle
clamp.
–
The position of the thread must be behind the
thread guide.
–
Draw about 4" (10 cm) of thread through needle
eye towards the rear of machine.
–
Place the thread to the back, under the presser
foot.
–
Thread the eye of the left needle
(9)
.
PLEASE NOTE:
Slip thread into the rear slot on the thread guide
(5)
and bottom slot of take–up lever cover
(6)
.
Then slip thread into the left slot on the thread
guide
(7)
, and into the left slot on the thread
guide
(8)
.
PLEASE NOTE:
Use of tweezers in the accessory case will make
needle eye threading easy.
