OptiPac 2652MD User's Manual
37
6
This chapter describes basic trouble-shooting procedures. It is divided
into four sections: “Before You Do Anything Else,” “Error Codes and
LCD Messages,” “Fuse Replacement,” and “If You're Still Having
Problems.”
Before You Do
Anything Else
Often, problems you're having can be resolved by verifying that:
•
The power cord is securely connected to the OptiPac and a wall outlet.
•
The power is switched on, and the AC fuse in the back of the drive is
not blown.
•
None of the pins on the cable connectors are loose, broken, or shorted.
•
All cables are installed correctly.
•
At least one side of the cartridge has been properly formatted.
•
Each peripheral connected to your computer has a unique address.
Error Codes and
LCD Messages
Occasionally, after installing an OptiPac, the system will display a disk
initialization error code upon start up. It is sometimes possible to solve
the problem by following the LCD instructions. Sometimes the LCD will
display an error code in the form of a number. This error code indicates
a problem that may be associated with another hardware device other
than the OptiPac. If this occurs, shut down your system and restart it
again. If the problem still occurs, contact Bering Technical Support at
(408) 364-6500.
Fuse
Replacement
If the drive fails to power on the AC fuse may be blown. The fuse is
located in the AC input jack.
Figure 6-1: Replacing the AC fuse
Spare
fuse
Fuse
TROUBLESHOOTING & SERVICE
6
