6
1.5. Other remarks and instructions
-
This Operating and Maintenance Manual provides all information on how to install, start and operate the
compressor. This manual should also be used when any maintenance work is carried out,
-
The Manual should be read and always available to the compressor operator,
-
During the maintenance work and periodic inspections, the provisions of the Warranty Book should be
observed,
-
The Maintenance section provides all measures and requirements necessary to keep the compressor in a
correct technical state,
-
Record all operating data, maintenance operations performed etc. into the Warranty Book. Observe all
reference and local safety regulations relating to the compressor, including those listed herein and in the
following sections,
-
Failure to follow the requirements included in this Operating and Maintenance Manual and Warranty
Book and/or unauthorised changes in the compressor or its integral units delivered by us shall make the
warranty null and void.
-
During warranty period, any repairs must be performed by the manufacturer service or authorised
service centre listed in the Warranty Book.
1.6. Warranty
BERG Kompressoren GmbH. Speddition Straße 21, 40221 Düsseldorf Germany hereinafter referred to
as the Warrantor provides the warranty for the products sold, ensures correct operation of the offered
products provided that they are used in accordance with their intended use and operating conditions
specified in this documentation.
The Purchaser shall lose its warranty rights for the product when:
-
The machine is used in a way non-compliant with its intended use,
-
Unauthorised modifications are carried out on the product,
-
Interventions are carried out by unauthorised persons,
-
Any repair attempts are carried out by unauthorised persons,
-
The obligation to carry out periodic inspections is not observed,
-
Non-original consumables are used.
The manufacturer reserves the right to make modifications in the product, resulting
from continuous technical development, without prior notice.
2. Operating safety rules
The present rules are valid for BERG screw compressors. In addition to the general health and
safety at work andthe Office of Technical Inspection (UDT) regulations applicable to compressors,
their assemblies and accessories, the safety instructions given below should be followed in
particular. The operators are supposed to observe safe work practices. It is the user’s
responsibility to continuously maintain the compressor fully operable. Components and
equipment considered to be no longer suitable for safe operation should be promptly replaced.
Adjustments, installation, operation, maintenance and servicing should be entrusted only to
properly trained, qualified and authorized staff.
The limit values (pressure, temperature, time settings etc.) are given in the Technical Data
section.
The limit values may not be changed by the user.
The manufacturer accepts no responsibility for any personal injuries, damage of equipment or
the compressor itself, at present and in the future, resulting from user’s negligence and failure to
observe the installation, operation and maintenance requirements contained herein. No
responsibility is also taken for failure to observe valid safety standards relating to the equipment
and qualified staff.
