Berbel Moveline BTH 100 ML, Инструкции по эксплуатации и монтажу

Страница: 19 / 36

19
Installation
6004067_a – 01.08.2018
EN
150 - 200
☞
Switch the device on.
☞
Drive the device approx. 150 to 200 mm upwards.
☞
Align the upper trim frame with the water drip bowl at
the front.
☞
Slide the upper trim frame over the device onto the
prepared work top.
☞
Make sure that the device can drive in or out without
touching the trim frame.
☞
Fully retract the device.
☞
Turn off the device.
☞
Disconnect the device from the power supply.
D
“4. Operation” (page 22).
3.5.7 Install the hob
☞
Mount the hob.
Observe the hob instructions.
☞
Check the hob seal (e.g. with silicone).
3.5.8 Connect accessories
Depending on the installation situation, accessories may be
connected to the hood:
y Wall box
y Window contact switch
y Under-pressure monitor
Observe the instructions for the accessories.
12 V DC
4 5 6 7 8 9
BMK-F F-K
2 3 1
D
A
B
C
E
F
G
H
12 V DC
GND X1 X1 X1 X1 X1 +
5 V
MFK MFK BMK2 BMK1
ST3
+
+
–
–
I
A Control box
y BMK1: Wall sleeve contact, optocoupler collector,
max. 12 mA / 12 V DC, safe galvanic separated
y BMK2: Wall sleeve contact, optocoupler emitter,
max. 12 mA / 12 V DC, safe galvanic separated
B Terminal “BMK-F” for the wall box connection
C Terminal “F-K” (multifunction contact) for the window
contact switch or under-pressure monitor connection
D Control line from the wall box
E Wall box
F Wall box power unit
G Window contact switch
H Control line from the window contact switch