Assembly & Adjustments
EXERCISE MONITOR FUNCTIONS
With your Programmable Magnetic Elliptical Trainer the single screen,
8 function Exercise Monitor is set to start automatically when you begin
to cycle. However, it is possible to switch on the monitor by pressing
the large Enter Button at the bottom of the monitor. To save
power, the monitor will also switch off after it has been idle for
approximately four minutes.
Please refer to the leaflet supplied with the Exercise Monitor for all
operational functions.
DRIVE BELT and FLYWHEEL ALIGNMENT
It may be necessary at some stage to adjust the Drive Belt (66) on your
Programmable Magnetic Elliptical Trainer. This can be achieved by
removing the 8 pre-fitted Machine Screws in the Chain Guards
(18L & 18R). Loosen the Flywheel Spindle Nuts (63) on both sides and
adjust the two 10mm Alignment Bolt Nuts. Please take care to adjust
each side equally to ensure that the Flywheel is kept in alignment and
that there is approximately 10mm of FREEPLAY on the Drive Belt when
correctly adjusted.
10mm
66
67
63
Alignment Bolt Nuts
Page 14
07PME
Programmable
Magnetic Elliptical Trainer
