Place the Rotation Rod (79) into the Handlebar Post (76) and slide on 1 x plastic
Spacer (82) to each side.
Attach the Upper Handlebars (6L & 6R) onto the Lower Handlebars (12L & 12R)
using 4 x M8 x 15mm Allen Bolts (9), 4 x M8 Spring Washers (10) and 4 x M8
Curved Washers (11) for each Handlebars.
Now slide the Left and Right Handlebars onto the Rotation Rod (79) and secure in
place with 1 x Plastic End Cap (61), 1 x Flat Washer (38) and 1 x M8 x 20mm
Coated Allen Bolt (34) for each side.
Finish off with 2 x Plastic Covers (83) on the Rotation Rod ends and the Centre
Plastic Covers (80) for the Handlebar Post (76) as shown below.
3
12
L
12R
38
61
76
34
79
6L
9
11
80
82
83
10
12
L
15
27
28L
34
35
77
28R
12R
29
30
76
22
22
10
Now attach the Footplate Support Bars (28L & 28R) by sliding them onto the Cranks (22) and
securing in place with 1 x M8 x 20mm Coated Allen Bolts (34) and 1 x M8 Flat Washer (35) for
each side. Tighten fully.
Align the Footplate Support Bars (28L & 28R) with the Lower Handlebars (12L & 12R) and attach
together with 2 x M10 x 80mm Bolts (27), 2 x M10 Flat Washers (29) and 2 x M10 Nylon
Locknuts (30) for each side. Tighten fully.
Finish off by fitting the 4 x Front Support Covers (15) using 8 x M5 x 50mm Screws (77) screwed
into the underside of the Footplate Support Bars (12L & 12R) as shown below.
4
Assembly & Adjustments
Page 19
07PME
Programmable
Magnetic Elliptical Trainer
