Bentone BF 1 FU, Инструкция по установке и обслуживанию

Страница: 36 / 44

36
Bentone
8.10.1 Replacement of complete electrical package
1. Disconnect the main power and shut off the fuel supply.
2.
Service position 2 can be used.
3. Remove the electrical connection from the motor.
4.
Remove the electrical box retaining screw.
5.
Remove the cable conduit entry to the ignition electrodes and the
preheater (where fi tted) and remove the photocell cable from the
motor fl ange.
6. Install the new electrical package.
7. Place the cable conduit entry and the photocell cable in position.
8.
Screw the electrical box in place.
9.
Connect the motor wiring.
10. Assemble the fan housing and burner front piece.
11. Switch on the main power and open the fuel supply.
12. Start burner and check/adjust combustion.
8.10.2 Replacement of individual electrical components
1. Disconnect the main power and shut off the fuel supply.
2.
Service position 2 can be used.
3. Remove the oil burner control.
4. Disconnect the wires to the components that are to be replaced.
5.
Insert the new wires.
6.
Install the oil burner control.
7. Assemble the fan housing and burner front piece.
8.
Switch on the main power and open the fuel supply.
9. Start burner and check/adjust combustion.
When replacing the electrical components transformer and control box
included in the electrical package, the junction box lid need not be removed.
!
When servicing/replacing components that aff ect combustion,
fl ue gas analysis and soot test must be carried out following installation.
8.10 Electrical module
Check that the electrical console retaining screw is tight so that good
contact to earth is established between the console and the burner body.