Bentone 650004465601, Инструкция по установке и обслуживанию

Страница: 23 / 44

23
Bentone
5.6 Hydraulic air adjustment
Stage 1
Set the control switch (S2) to low load (I). Undo the screw (E), turn the
damper to the desired position and retighten the screw (E).
Stage 2
Set the control switch (S2) to high load (I). Use the adjuster pin to screw the
sleeve (F) in (to reduce) or out (to increase). The position of the dam-per can
be read from the damper scale (G). Carry out flue gas analysis to check the
air settings
5.7 Air setting
When the burner’s power stage has been selected, check the setting values
for air dampers in table (3.6, 3.7). Read the damper angle for each of the
power stages This must then be used when the settings are made in the
burner’s control system (se punkt 3.3)
Check the air settings by conducting a flue gas analysis.
E F G