Bentone 650004465601, Инструкция по установке и обслуживанию

Страница: 28 / 44

28
Bentone
6.6 Replacement of electrical
components
1. Switch off the mains power.
2. Note the connection of the existing component.
3. Remove the existing component.
4. Install the new component using the same wiring as the existing
component or the specified alternative arrangement.
5. Turn on the mains power.
6. Check the function of the new component.
7. Start the burner and check the combustion.
! Use caution when
operating the
burner, surfaces
may be hot.
!
Use Loctite 5188 on threaded oil lines.
!
If the burner is directly connected, ensure that all
components on the burner are without power.
165 205 36 2020-11-02/5
!
When servicing/replacing components that affect combustion, an analysis and
soot test must be carried out on the installation.
6.5 Check oil line seals
Once the burner has been installed and commissioned, the seals of the
various coupling elements should be checked.
When a leak is detected, it is usually sufficient to tighten the coupling
element that is leaking.