27
Operation
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with a quick-release adjuster foot and a
rear adjuster foot. These adjusters change the image height and
projection angle.
To adjust the projector:
1. Press the quick-release button and lift the front of the
projector. Once the image is positioned as desired, release the
quick-release button to lock the foot in position.
2. Screw the rear adjuster foot to fine-tune the horizontal angle.
To retract the foot, hold up the projector while pressing the quick-
release button, then slowly lower the projector. Screw the rear
adjuster foot in a reverse direction.
If the screen and the projector are not perpendicular to each other,
the projected image becomes vertical trapezoidal. To correct this,
see
Auto-adjusting the image
for details.
Auto-adjusting the image
In some cases, you may wish to optimize the picture quality. To do this, press
AUTO
on the projector or
remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the
values of Frequency and Clock to provide the best picture quality.
The current input source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal is selected.
Fine-tuning the image size and clarity
To adjust the projected picture size, turn the zoom ring on the projector.
To sharpen the picture, rotate the focus ring on the projector.
Do not look into the lens while
the lamp is on. The strong light
from the lamp may cause
damage to your eyes.
Be careful when you press the
quick-release button as it is
close to the exhaust vent
where hot air comes from.
2
1
