26
Operation
Selecting an input source
The projector can be connected to multiple equipment at the same time. However, it only displays one
full screen at a time. When starting up, the projector automatically searches for the available signals.
If you want the projector to always automatically search for the signals:
• Under
the
Advanced
OSD menu, go to the
System Setup : Basic
menu, and enable
Auto
Source
. (see
"Auto Source" on page 43
)
• Under
the
Basic
OSD menu, if there’s no signal connected to the projector, go to
Auto Source
and
enable it; if there are signals connected, go to the
Settings
menu, and then enable
Auto Source.
(see
"Auto Source" on page 32
and
34
)
To select the video source:
1. Press
SOURCE
on the projector or remote control to display the source selection bar.
2. Press
/
until your desired signal is selected and press
OK
.
Once detected, the selected source information displays on the screen for seconds. If there are
multiple pieces of equipment connected to the projector, repeat steps 1-2 to search for another
signal.
The native display resolution of this projector is in a 16:9 aspect ratio. For best display picture results, you
should select and use an input signal which outputs at this resolution. Any other resolutions will be scaled by
the projector depending upon the Aspect Ratio setting, which may cause some image distortion or loss of
picture clarity. See "
Aspect Ratio
" for details.
Renaming an input source
You may rename the current input source on the source selection bar.
To do this, first and foremost, you have to access the
Advanced
OSD menu (see
30
for details).
1. Press
MENU
and then use / to go to
System Setup : Basic
.
2. Press
to
select
Source Rename
and press
OK
to display the
Source Rename
window.
3. Press / / / until your desired character is selected.
4. When done, press
BACK
to save your changes and exit.
HDMI1
HDMI2 MHL
Video
Component
PC
Source
