Bennett T-75, Инструкция по эксплуатации, обслуживанию и ремонту

Страница: 6 / 26

Bennett T75 Operation, Service, & Parts Manual Safety Information
4
GENERAL INFORMATION
Read this manual carefully and read all tags/labels attached to the T75 Pumping Unit before starting any maintenance and/or service. A pumping
unit that is not properly maintained will not perform properly and will void the Bennett limited warranty.
Before installation, operation, maintenance and/or service ensure that protection against lighting strikes are in accordance with the American
Petroleum Institute Recommended Practice RP 2003,
Protection Against Ignitions Arising out of Static, Lightening, and Stray Currents .
Service of the Bennett products and all accessories (e.g. Nozzles, Hoses, and Breakaways) must be performed by a technician who is trained in
accordance to all codes, requirements, standards, and regulations.
HAZARDOUS LOCATIONS
For safe operation, ensure that the dispenser is in a classified area as detailed below per NFPA 30, Flammable and Combustible Liquids Code and
NFPA 70, National Electric Code . For further information on the classification of locations for Fuel Dispensers, see NFPA 30, Flammable and
Combustible Liquids Code.
CODES AND STANDARDS
Follow all local, state, federal requirements, and accordance’s for installation of all equipment. Note: Refer to Appendices for approval
documentation .

ANSI/UL79 Power-Operated Pumps for Petroleum Dispensing Products

API 2003 – Protection Against Ignitions Arising Out of Stray, Lightning, and Stray Currents

International Fire Code – 2000 Edition

NFPA 30 – Flammable and Combustible Liquids Standard

NFPA 30A – Motor Fuel Dispensing Facilities and Repair Garages Standard

NFPA 70 – National Electric Code

OIML R117-1 Dynamic Measuring Systems For Liquids Other Than Water

PEI/RP100, Recommended Practices for Installation of Underground Liquid Storage Systems

PEI/RP200, Recommended Practices for Installation of Aboveground Liquid Storage Systems
UNAUTHORIZED ALTERAT ION OF BENNETT PRODU CTS
DANGER: BEFORE PERFORMING ANY TYPE OF SERVICE TO THE DISPENSERS, BE SURE TO SHUT OFF ALL ELECTRICAL SUPPLIES AND
SECURE THEM IN THE OFF POSITION. CLOSE ALL VALVES IN INCOMING PIPING. MAINTENANCE MUST BE PERFORMED
BY TRAINED PERSONAL ONLY.
Bennett Pump Company products are designed to meet or exceed the standards of Underwriters Laboratories, Inc., Federal Communication
commission, and National Institute of Standards and Technology. Compliance with these standards protects the operator and the consumer from
personal injury and ensure an accurate delivery of product. Any deviation from the use of authorized replacement parts or alteration of a designed
product configuration may cause personal injury, death or the revocation of one or all of the above approvals.
Bennett Pump Company will not assume responsibility or liability for any consequential injury or damage caused by the unauthorized alteration of
its products.
ABBREVIATIONS AND AC RONYMS
Term Description
AC Alternating Current
API America Petroleum Institute
DC Direct Current
dB Decibel
GPM Gallons Per Minute
Hz Hertz
kW Kilowatt
LPM Liters Per Minute
NEC National Electrical Code
NFPA National Fire Protection Agency
NPT National Pipe Taper or National Pipe Thread
OEM Original Equipment Manufacturer
PEI Petroleum Equipment Institute
PSIG Pounds per square inch gauge
THHN Thermoplastic High Heat-resistant Nylon-coated
UL Underwriters Laboratories, Inc.
VAC Voltage Alternating Current
VDC Voltage Direct Current