16
Preliminary check
It is indispensable to carry out several checks before starting installation:
• Try and open the gate manually, it must move without effort and without points of
resistance for the entire run.
• When left in any intermediate position the gate must not move.
• The leaf must be suitable for fixing to the rack (see dimensions and limits of use).
• The guides and components subject to wear must be in perfect working condition.
If this is not the case, replace the faulty parts.
• Check the stop retainers, controlling their efficiency also if the leaf should arrive
with force on the profile.
• The fixing area of the gear motor must not be subject to water stagnation or flooding.
If this is possible, envision a raised installation position.
• The door structure must be strong and rigid.
• The electric set-ups necessary for installation are highlighted in the “Electric con-
nections” paragraph. If they are not pre-existing they must be realised, with the
aid of a specialised technician, if necessary (electrician).
• With reference to Fig. 3, check the maximum and minimum clearances indicated
in measurements A and B.
The reliability and safety of the automation depend on the state of the
door structure.
Check that there is enough space for installation of the operator in safe
and comfortable conditions.
295
27
0
215
Technical Data, dimensions and limits of use
TECHNICAL DATA
PONY
Control unit power supply
230 Vac (PONY)
115 Vac (PONY 115)
50/60 Hz
Motor power supply
24Vdc
Absorbed power
80 W
Absorption
0,6 A
Torque
9 Nm
Operative intermittence
30%
Opening speed
10 m/1'
Protection rating
IP44
Functioning temperature
-20°C / +50°C
Driving gear for rack
M4 Z14
Noise
<70 dB
Weight
6,8 kg
DIMENSIONS
Fig. 1 indicates the main clearance dimensions of the gear motor complete with guide.
The measurements are expressed in millimetres.
If the rack is already present on the gate, it is important to consider the measurement
of the driving gear (89mm), for the correct coupling between the rack and the driving
gear.
Fig.1
120
27
0
185
89
If the rack is already present, check that it is well-fixed, in good state,
perfectly horizontal and that the pitch corresponds to that of the driving
gear, M4, i.e. about 12 mm between one notch and the next.
LIMITS OF USE
PONY can be used exclusively for residential sliding gates with a maximum weight of 400 kg.
The length of the leaf is not a restriction. In all cases it is recommended to install PONY onn
leaves with length exceeding 6m.
The materials with which the door is built, the state of maintenance and
particular conditions of use can reduce the values indicated.
In no case can the installation of PONY be considered a solution for
opening inefficient doors.
If the rack is already installed on the leaf:
- Fig. 2c installation with motor on the left
- Fig. 2d installation with motor on the right
Laying the foundation plate - Measurements
The positioning of the plate must respect the distances indicated in figures 2a/b/c/d
(seen from above):
- Fig. 2a installation with motor on the left
- Fig. 2b installation with motor on the right
0-50 mm
50-100 mm
90 mm
90 mm
Fig.2a
0-50 mm
40 mm
50-100 mm
40 mm
Fig.2b
Fig.2c
Fig.2d
Содержание 9592170
Страница 2: ......
