BENDIXKing KI 300, Руководство по установке

Страница: 48 / 50

____________________________________________________________________________
89000004-101 KI 300 Installation Manual
Rev 1 6-1
© Honeywell International Inc. Do not copy without express permission of Honeywell.
6 TROUBLESHOOTING
The following information can be utilized to recognize and correct probable malfunctions.
Table 6-1: KI 300 Troubleshooting
Symptom Possible Solutions
Attitude remains Red- X’ed

Ensure proper supply power is available.

Return unit for service.
Airspeed remains Red- X’ed

Ensure proper supply power is available.

Ensure airspeed limit has not been exceeded.

Return unit for service.
Altitude remains Red- X’ed

Ensure proper supply power is available.

Ensure altitude limit has not been exceeded.

Return unit for service.
Battery icon is Red- X’ed

Ensure battery is correctly installed.

Perform battery load test.

Replace battery.

Return unit for service.
Battery icon is Red- X’ed
For deeply discharged batteries, pre-charge as follows:
1. Apply power for 10 minutes
2. Momentarily remove power
3. Re-apply power.
4. Verify charging cycle starts correctly.
On Ground, Cross-Check
remains annunciated

Ensure proper supply power is available.

During power-on, ensure minimal aircraft motion is present.

Return unit for service.
Aligning message remains
annunciated

Ensure proper supply power is available.

During power-on, ensure minimal aircraft motion is present.

Return unit for service.
Altitude shows error

Perform altitude trim procedure.

Return unit for service.
Airspeed shows error

Perform airspeed trim procedure.

Return unit for service.
Attitude shows error

Set panel tilt correctly.

Set roll trim correctly.

Return unit for service.
IVSI shows constant offset

Set panel tilt correctly.

Set roll trim correctly.

Return unit for service.
Memory Error is shown

Return unit for service.