BENDIXKing KI 300, Руководство по установке

Страница: 35 / 50

____________________________________________________________________________
89000004-101 KI 300 Installation Manual
Rev 1 Page 4-8
© Honeywell International Inc. Do not copy without express permission of Honeywell.
Figure 4-9 Power On Screen
If the unit does not power-on, check the following:

Ensure power and ground connections are correct.

Verify the breaker is in the on position and applying power to the unit.

Verify the supply voltage is greater than 10V DC.

Verify the integrity of all electrical connections.

Test independent operation by removing the unit and powering from a dedicated cable and
bench power source.
After displaying the splash screen for approximately 25 seconds, the unit will enter the main operating
mode.
4.7.2 Entry & Exit From Setup Mode
Setup mode is enabled when the unit is powered-on while the rotary knob is being held in the pressed
state. After verifying basic power-on, cycle power to the unit and enter the setup mode. Upon
successful entry into the setup mode, the startup screen will be bypassed and a series of setup menus
will become available. The rotary knob can then be released once the setup mode is indicated.
Figure 4-10 Setup Mode Menu
Exiting the setup mode is accomplished by navigating to the last setup page and selecting YES, and then
pressing the rotary knob.
While in the setup mode, the unit is fully operational and will continue through the sensor stabilization
functions. Once stabilized, all displayed parameters will be shown, and any adjustments (such as
roll/pitch trim, IAS speed markings, etc), will all be updated real-time with user adjustment. This can be
useful for trimming certain parameters such as airspeed and altitude trim.