Bender UNIMET 300ST, Руководство по эксплуатации

Страница: 52 / 62

Maintenance and calibration
52 TGH1365en/10.2012
If several errors occur simultaneously, a different error code is given out.
Proceed as follows:
1. Shut down the UNIMET® 300ST and remove the mains connector.
2. Make a note of what happened prior to the error: operator inputs, type of DUT, ambient
conditions etc.
3. Keep the device serial number to hand.
4. Call Bender technical support and describe the type of error and the error code.
6.4 Disposal
Abide by the national regulations and laws governing the disposal of this device. Ask your supplier
if you are not sure how to dispose of the old equipment.
Directive 2002/96/EG on waste electrical and electronic equipment and Directive 2002/95/EG on the
restriction of certain hazardous substances in electrical and electronic equipment apply in the Euro-
pean Community.
In Germany, these policies are implemented through the "Electrical and Electronic Equipment Act"
of 16 March 2005. According to this, the following applies:

Electric and electronic equipment are not to be included in household waste. This is indicated
by the symbol:

Batteries and accumulators are not to be included in household waste but must be disposed of
in accordance with the regulations.

Old electrical and electronic equipment (WEEE) from users other than private households
which was introduced to the market after 13th August 2005 must be taken back by the manu-
facturer and disposed of properly.
Database (Code 032) This error appears when a bad data record which cannot be
corrected is detected in the device database.
The error can be eliminated if the data record where this error occurs
is deleted.
Firmware (Code 128) With a UNIMET® 300ST, the firmware of a UNIMET® 301ST has been
installed or vice versa
Type of fault Meaning