Bend-Tech Dragon A250 Series, Инструкция по сборке

Страница: 28 / 44

28 Bend-Tech Dragon A250 Assembly Manual
Leveling and Alignment
04
4.1.1 Checking Rail Level
Each Rail section should be checked for
level side-to-side and lengthwise using
a bubble level. If the Rail needs to be
adjusted, use the Swivel Levelers provided
with the Dragon A250. The Swivel Levelers
should be installed upon assembly.
4.1.2 Adjusting Swivel Levelers
To adjust the Swivel Levelers, ensure the
jam nut is loose and backed off to the base
of the Swivel Leveler.
Place an 11/16 in. wrench on the hex adjustment at the base of the Swivel Leveler. When
viewing from above, turn clockwise to raise the leg, turn counterclockwise to lower the leg.
4.2 Straightening the Dragon A250
Ensuring the Dragon A250 is straight is one of the most important steps in preparing the
machine for operation. Bend-Tech has found the simplest and best way to determine if the
machine is straight is to use a length of string. The string used during assembly at the Bend-
Tech facility has been provided with the machine. Follow the instructions regarding its use in
ensuring the machine is straight.
The machine will come with ¼ -20 ⅝ in. Allen head cap screws pre-installed on the Support
Leg at the Head of the machine as well as the rearmost Support Leg.
A string has been provided in the Misc. Box.
Bubble Level
Support Leg at the Tail of
the machine
Support Leg at the Head
of the machine
The string should be
positioned just under the
head of the Allen head cap
screw.