Bend-Tech Dragon A250 Series, Инструкция по сборке

Страница: 22 / 44

22 Bend-Tech Dragon A250 Assembly Manual
Assembling the Dragon
03
3.6.4 Slide Support Leg #5 into Position
Locate support leg #5 and slide it into position at the end of the first beam which is labeled
5. Ensure the swivel levelers are installed onto support leg #5 before proceeding with the
assembly.
3.6.5 Install the Third Beam
Locate the third beam, which will be labeled 5 at one end and 6 at the other end. Again, use
the stainless steel locating pins on the beam to align the beam when installing it.
Install the second beam so that the end labeled 5 is attached to the second beam and support
leg 5. If necessary, use a rubber mallet or dead blow plastic hammer to seat the beam sections
together. The end labeled 6 will need to be supported until the tail of the machine is installed.
3.6.6 Fasten the Support Legs to the Beams
Before installing the tail of the machine, secure
the support legs to the beams using 3/16 in. Allen
head screws and T-nuts. These can be found in
hardware Bag No. 1.
Using the magnetic tool provided, slide the T-nut
behind the support leg brace until it aligns with
the mounting hole in the support leg. Insert the
Allen head screw and thread it into the T-nut.
Repeat this process for all four fasteners on each
side of the support legs. Do not fully tighten these
yet.
T-nut
Magnet Tool
1/4 -20 5/8 in. Allen
head screw
5
6