Programming the Fire & Ice X-treme Game
1.) “Entering Programming Mode
To enter program mode, press and hold the right button located on the Power
Distribution Board. After 2 seconds, “TOTALS” will appear on the LCD Display. At
this time, release the button. “TOTAL PLAYS” with the number of credits played
will be displayed. The game is now in Program Mode
. PLEASE NOTE
that from
this point forward, the right (Button 1) and left (Button 2) buttons on the Power
Distribution Board are the buttons used. Each programming option is displayed on the
LCD Display (located in the lower cabinet at the rear of the cashbox enclosure), with
the functions shown for Buttons 1 and 2. In General, Button 1 changes the setting for
each programming option, and Button 2 advances to the next programming option.
Depressing Button 2 will advance to “TOTAL ONES”, which shows the number of
times only one ball scored. Depressing Button 2 will advance through the totals for
TOTAL 2, 3, 4, 5, 6, and 7 balls scored. The Totals displayed to this point are not
resettable and roll over at 1,000,000,000. Depressing Button 2 again will display
“COINS IN”
2.) “COINS IN”
The total coins received through the coin mechanisms are displayed. The total will
rollover to zero when it reaches 1,000,000,000. Depressing button 2 will display
“TICKETS OUT”.
3.) “TICKETS OUT”
The total tickets dispensed are displayed. The total will rollover to zero when it
reaches 1,000,000,000. Depressing button 2 will display “CLEAR TICKETS OWED
or "ENTER PROGRAMMING MODE?".
4.) “CLEAR TICKETS OWED?”
This option is displayed only if there are tickets that are owed that have not been
dispensed, and will show the number of tickets. Depressing Button 1 will clear these
tickets from the system, and “TICKETS CLEARED” will be displayed. Depressing
Button 2 will display “ENTER PROGRAM MODE?”
5.) “ENTER PROGRAM MODE?”
Depressing Button 1 at this time will enter the area of Program Mode where
parameters may be changed. Depressing Button 2 will return the game to Run Mode.
11
