5
Instructions for Use
·
The heater can be operated by the switches located on the left and right hand sides of the canopy.
Switches
Symbol
Functions
ON / OFF switch
O I
O=OFF; I=ON / Flame (without heating)
Heat
setting
switch
_
O
=
1000W heat setting
No heat
2000W heat setting
Thermostat
Rotate thermostat control clockwise or
anti-clockwise to achieve desired room temperature.
Maintenance
·
WARNING
: Before any maintenance and / or cleaning of the exterior of the heater, disconnect the heater form the power
supply and leave heater to cool down.
·
This heater does not use a standard bulb for its flame effect. The heater uses an electronically controlled LED system to
create the flame effect therefore no parts need to be replaced. There are no user-serviceable parts on this heater. Under no
circumstances should the heater be serviced by anyone other than a qualified electrician.
Safety Cut-out
·
This heater is fitted with a safety cut-out which will operate if the fire overheats (e.g. Due to blocked air vents). For safety
reasons, the heater will NOT automatically reset.
·
To reset the heater, disconnect the heater from the mains supply for at least 15 minutes. Check air vents for blockages and
then reconnect the supply to the mains and switch on the heater.
Care and Cleaning
·
Always disconnect the heater from the mains supply and allow it to cool down before any cleaning operation.
·
Trim parts may be cleaned using a clean, damp cloth. Never use abrasive cleaners and chemical agents as damage may
occur to the finish.
Technical Specification
·
Supply: 220-240V~ 50Hz
·
Rated power: 1800-2000W
·
Lighting: LEDs
