4
·
Inset Installation (Without spacer)
·
Mark the centre of the opening of the fireplace, measure 215.5mm to the left and the same distance to the right.
·
Measure from the hearth 560mm up the wall / back panel, mark the two locations, which are the centre of fixing screws.
·
Fit two screws into the marked locations and leave approximately 2mm gap (see diagram below)
·
Fit the heater by lifting it onto the two screws then lowering it into place.
·
Flat Wall Installation (With spacer) – Spacer is an optional extra 53mm 018376, 105mm 018384
·
The heater shall be secured to the wall using the 2 keyholes located in the spacer rear by the supplied screws.
·
Fit the two screws into the wall and leave approximately 2mm gap (see diagram below).
Fit the heater by lifting it onto the two screws then lowering it into place.
