Installation Instructions
This appliance has been tested and certified by Advantica Technologies Ltd and
carries the C.E. Mark.
The installation must be in accordance with the current I.E.E. Wiring Regulations.
Unpacking
After unpacking your cooker, make sure that you remove all the packing from the
grill compartment and ovens, and any stickers from the oven doors and the hob.
Examine your cooker for any damage. If there is any damage to your cooker or
anything is missing, please contact your supplier for advice.
Siting/Moving the
Your cooker is heavy, so be careful when moving or positioning it. Do not try
Cooker
to move the cooker by pulling on the doors or handles or control panel.
Your Belling electric cooker is designed to slot in between 600mm deep
cabinets spaced at least 915mm apart (DB9000E) or at least 1000mm apart
(DB1000E). It can also be used free-standing, with a cabinet to one side, in a
corner setting or with its back to a wall. However it must not be situated with
either side closer than 50mm to a combustible
wall or cupboard that is higher
than the cooker.
The wall behind the cooker and 450mm above and across the width of the
cooker, should be of an incombustible material or easy clean
surface such as
ceramic tiles. Please note, when positioning your cooker against a wall, ensure
there is sufficient clearance for the screw heads on the back panel.
This appliance can be of type X or type Y with regard to protection against
overheating of surrounding surfaces dependant on the location decided by the
user.
Any overhanging surface or cooker hood should be at least 650mm (25½") above
the cooker hob. We do not recommend positioning the cooker below wall
cupboards, as the heat and steam from the cooker may cause damage to the
cupboard and its contents.
Excess steam from the oven, vents out at the top back edge of the cooker, so
make sure that the walls behind and near the cooker are resistant to heat, steam
and condensation.
Your cooker must stand on a flat surface so that when it is in position the hob is
level. The cooker is fitted with rear wheels and will slide into position easily.
Movement of your cooker is most easily achieved by lifting the front, as follows.
Open the oven doors sufficiently to allow a comfortable grip on the underside front
edge of the oven roofs, avoiding grill elements or oven furniture.
“DO NOT LIFT THE COOKER BY THE HANDLES”
Adjust the cooker at the rear to the required height, using the 2 jacking screws
situated behind the rear access cover and secure with the lock-nuts. Position the
cooker and adjust the height at the front with the 2 jacking screws situated at the
front underside. Check that the cooker is level by using a spirit level (adjusting the
jacking screws if necessary). It is important that the cooker is stable and level for
the overall cooking performance.
Whatever the position, remember to leave enough room for the cooker to be
pulled out for cleaning and service.
5