ISS 5, SECTION 573-127-703
2. 24
Clutch Mechanism (continued)
CLUTCH MAGNET ASSEMBLY (Preliminary) (Continued)
(3)
Requirement
With
magnet assembly replaced and clutch disengaged, clearance between end of
armature bail extension and main bail latch
0.007
inch---Max
0.015
inch
To Adjust
With magnet bracket mounting screws friction tight, move bracket to its lowermost
position. then position bracket by means of adjusting lug on bracket (visible through
hole in rear plate). Tighten screws. Refine requirements if necessary.
Note: The above adjustments may be considered final unless ac power is used, a
check should be made to insure that the chatter is at a minimum. If excessive
chatter is present, Requirement
(
1)
will have to be refined and Requirements
(2)
and (3) rechecked.
(Rear View)
ARMATURE BAIL
EXTENSION
ADJUSTING
LUG
MAGNET
BRACKET
MOUNTING
SCREWS
I
_j
Page 27
