2.16
Feed Wheel Mechanism
(B)
FEED RATCHET DETENT SPRING
Requirement
With main shaft in stop position
and feed pawl held away from
its ratchet
8
oz---Max
13
oz
to start roller moving away from
ratchet.
MAIN BAIL
TRA NSFER LEVER
GUIDE POS T
TOP PLATE
(Front View)
ISS 5, SECTION 573-127-703
(C)
MAIN BAIL TRIP LEVER
Requirement (Replace top plate)
Unit in stop position, clearance between tip
of highest sensing pin and top surface of
tape guideplate should be flush to
0. 005
i
n
c
h below.
To Adjust
With clutch disengaged, loosen front and
rear transfer lever guide eccentric post
locknuts. Position highest point of
eccentric post (as indicated
b
y dot on end
of post) t oward left and rotate post so
that its eccentric positions trip lever.
Tighten locknuts.
FEED WHEEL
RATCHET
MAIN BAIL
ECCENTRIC
FEED WHEEL DETENT
ECCENTRIC
(A) MAIN BAIL S PRING
TAPE
GUIDE
PlATE
Requirement ( Top plate removed)
Clutch disengaged, unit on its back. Spring
unh o oked from main bail
6
oz---Max
10
oz
to pull spring to installed length.
Page
19
I
.J
