Belden HIRSCHMANN 70914569, Руководство пользователя

Страница: 18 / 30

18
Installation SPIDER II 16TX
Release 02 12/2014
2.4 Operating the device
By connecting the supply voltage via the terminal block, you start the opera-
tion of the device.
2.5 Connecting data cables
Note: In general, adhere to the following recommendations for data cable
connections in environments with high electrical interference levels:

Keep the length of the data cables as short as possible.

When using copper cables, verify that there is a sufficient gap between
the power supply cables and the data cables when laid over a long
distance. Ideally, install the cables in separate cable channels.

Use shielded cables.
Note: Verify that you connect only optical ports with the same optical trans-
mission properties with each other.
You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
CAUTION
ELECTRIC SHOCK
Connect only a supply voltage that corresponds to the type plate of your
device.
Failure to follow these instructions can result in injury or equipment
damage.