Belden FX Fusion Splicer, Руководство пользователя

Страница: 64 / 66

PX106545-EN, Rev.A 62
9.2 Splice
 The error message displayed on the screen.
 Refer to the Error message list.

Splice loss is high or irregular.

Clean V-groove, V-block, reflector and object lens by referring
to [Maintenance of splice quality]. Replace electrodes by
referring to [Electrodes replace]. Refer to the
“High estimated
loss” from [Error message list].

If fiber warps or is bent, place the fiber bent direction to face the
bottom. Splice loss varies depending on cleaving angle, arc condition
and cleanliness level of fiber. If splice loss is still high or irregular even
after implementing these recovery measures, contact Belden. Annual
maintenance is required to maintain optimal splice quality.

The monitor is suddenly turned off.

Refer to [Monitor sleep mode menu].

Power is suddenly turned off.

Refer to [Splicer sleep mode menu].

Either arc amount or arc time does not change.
 On SM, NZ, MM or AUTO mode, either arc amount or arc time does not
change. Implement [Arc Calibration] and the arc amount on these
modes properly maintain. When used in another mode, arc amount and
arc time are automatically set to prevent their alteration.

Set pause.

Refer to [Option menu].
 Indicate cleaved angle, fiber angle, and clad deviation.

Refer to [Option menu].

Estimated splice loss and measured splice loss do not match.

The estimated splice loss is a calculated value so it should be used only
as a reference.