DURAFLO™ 18 GPM PUMPING STATIONS
1MANUL375
Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470* Ph (248) 349-7010 * Fax (248) 380-9681
19
Maintenance
Powder Coating Maintenance
Just as washing your car is important for removing dirt and grime, your powder coated equipment needs to be given a
regular wash to keep it looking good. In conjunction with a regular maintenance program, your powder coated
equipment requires special care to maintain its durable finish, and is a smart way to protect your investment.
The effects of atmospheric pollution, general dirt, grime and airborne salt deposits can all accumulate over time and
should be removed at regular intervals. As a general rule powder coat cleaning should take place every six months. In
areas where pollutants are more prevalent, cleaning programs should be carried out on a more frequent basis i.e.
every three months.
Cleaning Procedure
Cleaning should start at the time the product is installed, ensuring that construction materials such as concrete, plaster
and paint splashes are removed before they have a chance to dry. Failure to remove these materials at an early stage
will require the use of aggressive cleaning materials and techniques with potential damage to the powder coated
surface.
The best method of cleaning is by regular washing of the coating using a solution of warm water and non-abrasive, pH
neutral (pH 5 -8) detergent solution.
1.
Spray the powder coated surface with a garden hose to rinse off any loose dirt or debris. DO NOT use a power
washer or high-pressure water as this can wear and cause harm to the powder coated surface.
2.
Using a mild detergent and warm water clean the powder coat surface with a soft cloth, sponge, or a soft natural
bristle brush. DO NOT use water heated to a temperature above 140° F, as this can wear and cause harm to the
powder coated surface.
3.
Rinse the sponge or soft brush as needed to prevent any abrasive debris from collecting on the cleaning surface.
4.
Thoroughly rinse the powder coat surface with a garden hose after cleaning it to rinse off and remove all detergent
residues.
Tips & Warnings
•
Over-cleaning or excessive rubbing can do more harm than good
•
To prevent marring, make sure cleaning sponge, cloth, etc., are grit-free
•
Abrasive materials such as steel wool, abrasive brushes, etc., can wear and harm finishes
•
Do not scour painted surfaces
•
Do not under any circumstances use strong solvents such as thinners, aggressive alkaline, acid or abrasive
cleaners
•
Do not use a power washer, high-pressure, or water heated above a temperature of 140° F, as these can wear
and cause harm to the powder coated surface
•
Always use a test surface first
•
Use nothing stronger than white spirits to assist with stubborn stains. Cleaning with white spirits should be carried
out in shade and during cooler temperatures using a soft cloth and gentle wiping only. It is also recommended that
a small non-visible area be tested initially to ensure that no color change or damage will occur
If you have any questions or concerns regarding how to clean powder coat equipment
please call Belanger® Technical Support / Aftermarket Group for additional assistance.
