Beckman Coulter Avanti JXN-26, Руководство пользователя

Страница: 165 / 210

PN B38322AA 7-11
Maintenance and Troubleshooting
JCF-Z Rotor Identification
7
3
Repeat step 2 on the right side
The second latch engages.
JCF-Z Rotor Identification
The rotor identification system can, under two specific conditions, misidentify the JCF-Z
continuous flow/zonal rotor. If the rotor is misidentified, the the run will be stopped. Follow the
steps below to resolve the issue.
NOTE
Misidentification can be prevented by returning your JCF-Z rotor to the Beckman Coulter factory to
have magnets added to the rotor body. The magnets ensure correct identification. Call your local
Beckman Coulter Representative
*
for more information.
JCF-Z rotors manufactured after March, 1997, have factory-installed magnets.
1
On the first few uses of a new JCF-Z rotor, or in an older JCF-Z rotor with newly replaced bearings
, run
the rotor from 0 to 5000 RPM and back to 0 RPM three times.
This procedure will distribute lubricant around the bearings in the rotating seal assembly,
reducing drag.
2
In older JCF-Z rotors with bearings that have not been replaced recently , follow the same procedure
as for a new JCF-Z rotor (perform three runs from 0 to 5000 RPM and back to 0 RPM) to ensure
that the bearings are properly lubricated.
If misidentification recurs after the third run, when the bearings are lubricated, this indicates
that the bearings are worn and need to be replaced.
a.
Replace the bearings following the instructions in the JCF-Z manual (JCFZ-IM).
NOTE
If the JCF-Z rotor is misidentified, the run will be stopped.
Storage and Transportation
To ensure that the instrument does not get damaged, contact your Beckman Coulter Representative
for specific instructions and/or assistance in preparing the equipment for transport or long-term
storage.
* In the United States, call 1-800-742-2345. Outside the U.S., contact your local Beckman Coulter office or visit us at
www.beckmancoulter.com.