Becker E12, Руководство по сборке и эксплуатации, Страница: 18 / 28

Start point to retracted stop
Retract
Extend
Set both switches to the programming setting.
Use the operator control to move the sun protection system to the desired maximum
projection. This must be at least 2.5 revolutions of the barrel away from the retracted
limit position. At this time, it is still possible to amend the position.
Stop the sun protection system at this point.
Then, retract the sun protection system without interruption until the tubular drive
switches off automatically.
Installation is now complete; electronic limit switching has saved the limit positions.
As a final check, run the sun protection system to the two limit positions again.
To ensure that the limit position is reliably detected and the sun protection system is
fully closed, the tubular drive pulls the cloth slightly more strongly during the installa-
tion.
Auto point to retracted stop (only with articulated-arm awnings)
Attention
Ensure that the cloth is not wound up the wrong way by the barrel.
Retract
Extend
Set both switches to the programming setting.
Extend the articulated-arm awning until the articulated arms are fully protracted and
the cloth is lying loosely over them.
Stop the articulated-arm awning at this point.
Then, retract the articulated-arm awning without interruption until the tubular drive
switches off automatically.
Installation is now complete; electronic limit switching has saved the limit positions.
As a final check, run the sun protection system to the two limit positions again.
To ensure that the limit position is reliably detected and the sun protection system is
fully closed, the tubular drive pulls the cloth slightly more strongly during the installa-
tion.
18 - en